欢迎进入美莎防水 上海荣拓实业有限公司
加入收藏联系我们
全国服务热线:021 - 6811 1319
厂房维修
当前位置:上海荣拓实业有限公司 >> 新闻中心 >> 行业新闻 >> 浏览文章

JS复合屋顶防水涂料的施工原理

标签:复合,屋顶,防水,涂料,施工,原理 时间:2024年03月28日 阅读254

基面的清理可用冲洗法也可用清扫法进行,使用冲洗法应保证在基面无明水的条件下,进行下一步施工;
Basal clean-up available rinse method can also be used in cleaning method, douche should ensure that under basal NO Mingshui, the next step of construction.
对周全施工基面进行底涂。对排水孔、穿墙管、裂缝、分割缝、阴阳角等节点、细部进行预增强处理;
The overall construction of the base surface coating. The drainage hole, wall pipe, crack, split seam, yin and yang angle node, details of pre emphasis processing;

下层处理打底层:水泥:细沙:乳液=1:1:0.2:0.2。若施工基面粉化,沙化,平整度达不到要求,可按打底层配比配制聚合物抹面砂浆将基面修复。修复时先将基面用水充分湿润,待无明水后,用拌好的聚合物抹面砂浆,将基面薄刮一遍。如许可以进步工程质量,降低施工成本;

上海专业屋顶防水

The base layer: cement: Sand: emulsion =1:1:0.2:0.2. If construction of the base surface of powder, desertification, flatness is not up to the requirements, according to the hit ratio of the underlying preparation of polymer finishing mortar base surface repair. Repair the surface water to fully wet, to be no Mingshui, with a good mix of polymer finishing mortar, surface thin scratch again. This can improve the engineering quality and reduce the construction cost;
混料方法:按施工要求比例将粉料倒入乳液桶内,用搅拌器搅拌均匀即可使用;
Mixing method: according to the proportion of the construction requirements will be powder into the emulsion barrel, with the mixer can be used to mix;
铺贴加筋布粘接层品牌策划,一次可按布宽涂刷5—10米长潍坊设计,趁湿立即铺开,用刮板梳平所有皱褶.赶出气泡,并使布下的涂料透过布上。如出现皱褶、空鼓(因布没粘牢)均应剪开.用涂料重新粘好;
Paving and reinforced bonding layer, a can according to broad brush cloth 5 - 10 meters long, while wet immediately spread, scraper flat comb all the creases. Out of the bubble and make cloth coating through the cloth. Such as the emergence of wrinkles, hollowing (due to cloth by mistake) should be cut by coating reattached;
参考用量(粉料+乳液)及涂层成膜厚度。
Reference dosage (powder + emulsion) and coating film thickness.