1、将液体添加剂倒入干净的搅拌容器中，然后按比例一边搅拌一边缓慢加入粉料，充分搅拌3-5分钟直至生成无粉团的、均匀的胶浆，并在操作时间内用完。建议使用机械搅拌（400-500转/分钟），以取得最佳的搅拌结果；
1, the mixing container liquid additives into clean, and then according to the proportion while stirring slowly add powder, paste stir until generating 3-5 minutes of dough, uniform, and used in operation time. Mechanical agitation (400-500 / min) is recommended to obtain the best mixing effect;
2、用辊子、刷子将浆料均匀涂刷于处理好的底材上，根据使用环境及性能要求涂刷2层或2层以上； 一般屋面工程屋顶防水层厚度为1mm，地下工程施工规范厚度要求为1.5-2mm；
2, with a roller brush, paste evenly on the substrate treatment is good, according to the requirements of the use of the environment and performance of brushing 2 or more than 2 layers; the general engineering waterproof layer thickness of 1mm, regulate the construction of underground engineering requirements for thickness 1.5-2mm;
3、做完一层后，必须待其略为干固（刚好不粘手）后，再做第二层，一般通常需1-3小时施工，详细情况视基面的密实度以及当时的气温而定。假如超过24小时，或涂层已经固化，在其上涂刷第二层时，必须先用清水重新润湿外观；
3, finish a layer, which must be slightly dry (just not sticky), then do second layers, usually takes 1-3 hours, depending on the surface density and the temperature was determined. If more than 24 hours, or the coating has been cured, in the second layer of coating, must first re wetting the surface with water;
4、养护固化：浆料涂刷后第二天起，建议用细雾喷水或湿布覆盖涂层2-3天，再进行闭水试验；对于长期盛水的水池应待其空置两周后才盛水；
4, maintenance and curing: second days after brushing slurry, with fine mist spray water or wet cloth to cover for 2-3 days, then the closed water test; for the long-term water pool should wait two weeks after a vacancy;
5、搅拌好的浆料一般正常宜在1小时内用完，出现凝固的材料不可再用；切勿掺水搅拌，也不要随意改变乳液的比例。
5, the well mixed slurry should be finished within 1 hours, the solidification material can not be reused; do not water mixing, also do not change the proportion of emulsion.
