（1）首先应确定是否为设计与结构不合理造成渗漏。若是，应首先消灭幕墙结构上不合理应力。
(1) first of all, it should be determined whether the design and structure is not reasonable cause leakage. If, it should first clear the structure of the wall is not reasonable stress.
（2）对原幕墙外观材质进行分析。
(2) analysis of the surface material of the original curtain wall.
（3）选择配套的密封材料及基底处理剂，并进行幕墙密封粘接的指标测试，各项指标应达到国家标准。
(3) the selection of the matching of the sealing material and the substrate treatment agent, and the curtain wall sealing adhesive test indicators, the indicators should reach the national standard.
（4）剔除幕墙原有密封材料。
(4) removing the original sealing material of curtain wall.
（5）用砂纸及清洗剂将被密封部位清洗干净。
(5) with sandpaper and sealing parts cleaning agent will be clean.
（6）将防污护面胶带贴于被密封部位两侧。
(6) the antifouling protective tape affixed to the sealing parts on both sides.
（7）在被密封部位外观涂刷基底处理剂。
(7) brushing the surface of the base of the sealing surface treatment agent.
（8）填塞衬垫材料，视板缝宽度大小（辽宁人事考试网站武汉网站建设），填入直径比宽度大３～5ｍｍ的聚乙烯泡沫棒材，并调整到缝隙深度等于宽度的0.5～0.7倍为宜；
(8) packing pad material, as the seam width size in diameter than the width of 3 ~ 5mm polyethylene foam bar, and adjust to the gap depth equal to the width of 0.5 ~ 0.7 times;
（9）调整胶枪口径，将密封材料嵌入密封部位，并用刮刀修整外观。
(9) to adjust the diameter of the glue gun, the sealing material is embedded in the sealing part, and the surface is trimmed with a scraper.
（10）揭除防污护面胶带。
(10) removal of antifouling protective tape.
