1、施工前应保证下层温度高于露点温度3℃，施工过程中应保持延续搅拌；
1, the construction should ensure that the basic temperature is higher than the dew point temperature of 3 degrees C, the construction process should be kept continuous mixing;
2、若检验时发现涂层有鼓泡、漏喷等缺陷，则必要立即进行修补；
2, if the test found that the coating has a bubble, leakage and other defects, the need for immediate repair;
3、如缺陷部位发现离喷涂时间较短（≤6h），可对缺陷涂层外观进行打磨，清理后直接进行二次喷涂；
3, such as the defects found from the spraying time is short (less than 6h), the defects of the coating surface grinding, cleaning up directly after the two spraying;
4、假如缺陷部位发现离喷涂时间较长（＞6h），则应对缺陷涂层外观（向外扩展5～10cm范围）打磨清理后，施作专门的处理剂，然后采用专用修补设备喷涂LM复合防腐屋顶防水涂料并修补刮平（河北人事考试网站），使整个涂层延续、致密、均匀。
4, if the defective parts found from the spraying time is longer (more than 6h), then deal with the defects of the coating surface (extended range of 5 ~ 10cm) grinding after cleaning, apply special treatment, and then use special equipment repair sprayed LM composite waterproof anti-corrosion coating and repair, scraping, make the whole continuous, dense and uniform coating.
5、雨天不得施工；四级以优势力不宜施工；
5, rainy days shall not be constructed; more than four wind construction;
6、施工现场应安全用电，杜绝火源并配备好响应的消防器材。
6, the construction site should be safe use of electricity, put an end to fire and equipped with appropriate fire equipment.
